Description
Maye you need other Product
DC24V WS2811 Led Strip Running Water Light 120led/M SMD2835
Led Description:
package:Comtrol+DC24 Led Strip
1. LED type: SMD 2835 belt control IC WS2811
2. PCB color: white PCB
3. The number of leds: 30 leds / 60 leds / 90 leds / 120 leds/m
4. Length: 5 m/10m/15m/20m
5. Power: 24 w/m (120 leds/m)
6. Waterproof level: IP33 – not waterproof, waterproof IP65 – silicon coating
7. PCB width: 120 leds/m bar – 8mm/10 mm
8. Working voltage: DC24V
9. Working temperature: — 20 to 50 °
10. Visual Angle: 120 °
11. IP30 / IP65 with double-sided tape on the back
12. Color: single color
Outgoing mode: SM3pin terminal head and 2 power cords
Red: 12V positive pole (VCC)
White :12V negative (GND)
Green: signal line (DATA) the two extra lines are backup power lines, red :12V positive pole/white :12V negative pole
Waterproof grade: IP30 bare board: the lamp beads exposed outside are not waterproof (there is double-sided tape on the back);
IP65 glue drop: the lamp bead is covered with high transparent resin to prevent a small amount of water splash (double-sided glue on the back)
IP67 casing: use silicone casing with good light transmission and outdoor rain protection (non-double-sided adhesive on the back) packaging: anti-static bag, naked version, double-sided adhesive on the back of drip adhesive, non-double-sided adhesive on the casing;
Main features:
An IC chip controls an LED bead to form a loop. The controller controls the circuit above the FPCB circuit board through the IC chip to achieve different LED effects: chase, running, running, discoloration, breathing, flash, clockwise running, counterclockwise running, simulating lightning, etc. Cutting and welding are convenient and free: each LED can be formed into a loop, which can be cut off and welded to meet the customer’s requirements of various length of lamp strip
Control Description
Running Water Control:
Flow control, running after the constant light bar
Backflow Control:
Reflux controller, switch on the signal after the light strip running constant, disconnect the trigger after the light strip flowing back, the effect is more cool
Led stirp picture


Control Description picture
Control Description No trigger, electricity can be used

Backflow Control picture
Backflow Control With a trigger, need to switch on the trigger (two lines at the output signal end), the water runs after contact, and the water flows back after disconnect
Turn on the light white water often bright, turn off the light reflux off
Button operation instructions:
Mode + : This button simulates the wall switch. Press the button to indicate that the wall switch is on, and the white light of the light bar is always on; release the button to indicate that the wall switch is off, and the white light is back off.
Speed: Adjust the flow SPEED, the SPEED of 10 levels can be adjusted
Mode – : Long press the button for 5 seconds when the light is off to enter the menu of adjusting points.
Controller adjusting point method:
1. Adjust in the light off state (note that the light must be off to adjust)
2. Long press the MODE- key for 5 seconds to enter the menu of adjusting points, then the light will light up
3. Press Speed and Mode – to add or subtract points.
(Press SPEED to add points, press MODE- to subtract points, hold on for quick adjustment)
4. Press MODE+ to save and exit after adjustment.
The default factory 50 points, the maximum can be adjusted to 2048 points

1 review for WS2811 Led Strip Running Water Light 120led/M SMD2835 Use In Sitting Room Bedroom Roof Decoration With Led Controller DC24V